Construction method of insulation layer7

According to the size and structure of the cold storage, the optimal position for installing the air cooler should be determined based on the direction of the door opening and the position of the unit. The distance between the return air surface and the wall panel should not be less than 40cm. When there is no protection at the top of the civil engineering warehouse, the distance from the top should not be less than 100mm. The maximum point of deformation curvature of the cooling fan mounted directly on the storage plate shall not exceed 2cm, otherwise it is 2

This must be reinforced with a storage board, or the air cooler must be fixed on a bracket, or secured with a bracket. When lifting, a manual hoist can be used

Check whether the model of the air cooler is consistent with the design, including medium temperature, low temperature, high temperature, evaporation area, electricity, etc

6. Are there any external injuries to the air cooler? The air cooler is filled with protective gas when it leaves the factory. Before welding, the protective gas should be vented first, and then the blocking plate and plug should be welded off. Be careful not to burn the paint of the air cooler 4 with flames during welding.